Vacuum Fume Extractor SUPPLIER operating precautions have the following points:

1. Before turning off the fan, you need to turn off the vacuum cleaner of the woodworking equipment. After the system runs for 3-5 minutes, close the host.

2. Before turning on the fan, you need to turn on the end air outlet of the vacuum system 3-5, and then turn on the vacuum fan.

3. Check whether the connection parts are connected firmly.

4. Check the gas tightness of the combination of dust collector and ash, ash bucket and ash device, and ash -mouting device to eliminate the phenomenon of ash and air leakage.

5. Turn off the small baffle valve, start the ventilator, and gradually open the large baffle valve after no abnormal phenomenon, so that the dust collector can be used to contain the amount of dust -containing gases.

6. The use of pulse controller:

1) Open the power switch, the power supply indicates the light emitting tube, the digital tube displays the corresponding numbers in order, adjusts the pulse interval and the pulse width potentiometer, so that the dust collector is in*working state. Adjust the time clockwise, the interval and width time increases, and the instead decreases.

2) V1 is the working voltage of the logical circuit (DC220V or DC24V)

V2 is the working voltage of the solenoid valve (AC220V or DC24V)

3) There is a dial switch in the center of the panel: the number of doors (output signals) can be adjusted according to the customer's needs.

4) Repeated switch: When the solenoid valve of a certain road needs to work repeatedly, you can turn on the repeat switch. At this time, the digital tube will repeat the number of the door, and the controller will repeat the signal of the road. (Please note, do not dial the switch at the moment when the number of doors is conversion.)

Vacuum Fume Extractor SUPPLIER Running Technical Requirements:

① When the temperature of the dust is changed, pay attention to the attachment, blockage and corrosion of dust.

② Pay attention to changes in pressure differences, because wear and corrosion can push the dust collector, which will promote the decrease in dust removal efficiency and change the pressure difference.

③ Pay attention to the gas tightness of the dust collector, check the changes in the flow of pulse air and the concentration of dust collection.

vacuum fume extractor supplier https://www.kaisenfilter.com/High-Vacuum-Fume-Extractor